5x7“H- Bar” Aeroponic / Hydroponic
Manifoldfor Cloning & Net Pot Wetting
10red 360 Degree Sprayers
Buildyour own Cloning Bucket
Consistsof:
1x 5x7 inch “H” Bar with 10, 360degree spray heads (12 included)
1x 8 inch riser (can be cut for best size fit)
1 ½ inch male hose connector with tubing
Manifoldis ½ inch CPVC and all sections are glued except where the riserpops into the “T”. You can glue it in place or leave it as a blowout point if the sprayers get jammed. This will take pressure off thepump and keep it from failing. Based on a riser height of 8 inches orbelow a 150 GPH pump should work. The ½hose connector segment allows for attaching to the pump,by hose.
Usinga 150 gph pump the spray area can be up to 40 x30 inches in coverage. This can be seen in the UV/fluorescenttest picture.
Whatyou do:
Gentlyscrew in the spray heads. Don\'t over tighten and snap them off.
Selectyour riser height or keep it as is.
Insertthe riser into the “H”.
Connectthe manifold to the pump with the ½ inch hose connector end of theriser.
Pumpnot included.